Transmission Fluid Level Inspection
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle. Lifting and Jacking the Vehicle
Disconnect the clip (1) retaining the cooler pipe to the transmission bracket.
- Reposition the cooler pipe to allow access to the transmission oil filler plug.
- Remove the transmission oil filler plug from the transmission.
- NOTE:
Transmission fluid level setting must be followed exactly as written or the transmission may be overfilled or under filled.
For fluid recommendations, refer to Adhesives, Fluids, Lubricants, and Sealers .
Transmission fluid level MUST be 3.2 mm (1/8 inch) below (1) the transmission oil filler plug. This can be done by one of the following methods:
- Bend mechanics wire to 3.2 mm (1/8 inch) to check fluid level. Add or remove fluid as necessary.
- Fill transmission until level with the bottom of the fill plug hole, then remove 240 ml (8 ounces) of fluid.
- Install the transmission oil filler plug to the transmission and tighten. Fastener Specifications
Inspect the clip for proper retention on the cooler line to the bracket. Replace the clip as necessary.
- Reconnect the clip (1) retaining the cooler pipe to the transmission bracket.
- Run the engine in Neutral for two minutes to allow the fluid to recirculate.
- Remove the transmission oil filler plug and verify the fluid level is 3.2 mm (1/8 inch) below the transmission oil filler plug hole. Add or remove transmission fluid as necessary.
- Apply sealant to the transmission oil filler plug. Adhesives, Fluids, Lubricants, and Sealers
- Install the transmission oil filler plug to the transmission and tighten. Fastener Specifications
- Lower the vehicle.
CAUTION:
Refer to Fastener Caution .
NOTE:
Ensure the clutch pedal is NOT depressed.