Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
Install the manual transmission control lever lower boot (1) to the manual transmission control (2).
Front Floor Console Wiring Harness Extension Harness (1) - Install
Wireless Charging System Module (2) - Install
- Wireless Charging System Module Bolt (1) - Install and tighten [2x] - Fastener Specifications
- Connect the electrical connector.
Vehicle Stability Control System Switch (2) - Install
- Auxiliary Multifunction Switch Bolt (1) - Install and tighten [3x] - Fastener Specifications
- Connect the electrical connector.
Connect the electrical connector.
- Front Floor Console Trim Plate (1) - Install
If NEW threaded components are being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded components are reused, prepare the threaded components using the following steps:
- Remove any loose cured adhesive from the external threads of the components using a lint free cloth.
- Thread the cleaned components into the internal mating threads and remove to loosen trapped cured adhesive.
- Apply thread locking adhesive to the external threads of the components. Adhesives, Fluids, Lubricants, and Sealers
- Ensure there are no gaps in the thread locking adhesive once applied to the component.
- Position the transmission control lever lower boot and knob as an assembly (1, 2) on the manual transmission control lever.
- Tighten the manual transmission control lever knob bolt (3). Fastener Specifications
- Install the manual transmission control lever lower boot (2) to the console.
CAUTION:
Refer to Fastener Caution .