Clutch Housing Assembly

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Transmission Fluid Pump Outlet Pipe Fitting (1) - Install NEW and tighten - Fastener Specifications
Transmission Case Plug (2) - Install NEW and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Transmission Fluid Pump Check Ball (3) - Install
Transmission Fluid Pump Check Ball Spring (2) - Install
Transmission Adapter Plug (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

The transmission fluid pump needs to be coated and filled with transmission fluid before installation. Adhesives, Fluids, Lubricants, and Sealers
Transmission Fluid Pump (2) - Install
Transmission Fluid Pump Retaining Ring (1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
If the 1st/2nd speed shift shaft bearing is installed incorrectly it will interfere with the inner shift rail seal causing a leak.

Use the J-36190 Universal Driver Handle (1) with the J-44384 Bearing Installer (2) to install the shift shaft bearing flush (3) with the clutch housing.
Courtesy of GENERAL MOTORS COMPANY

Use the J-36190 Universal Driver Handle (1) with the J-39439-1 Shift Rail Bushing Removal/Installer (2) to install the 3rd and 4th speed shift shaft bushing (3) flush with the clutch housing.
Courtesy of GENERAL MOTORS COMPANY

Use the J-39433 Input Shaft Seal Installer to install the input shaft seal (1).
Courtesy of GENERAL MOTORS COMPANY

NOTE:
One or more shims may be used.

Install one or more countershaft bearing shims (2). Shimming Procedures
Install the countershaft bearing race (1).
Courtesy of GENERAL MOTORS COMPANY

Install one or more input shaft bearing shims (2). Shimming Procedures
Install the input shaft bearing race (1)