Removal Procedure
- Place the ignition switch in the OFF position.
- Apply and release the brake pedal several times until the brake pedal becomes firm to deplete the power brake booster vacuum reserve.
- Air Inlet Grille Panel - Remove - Air Inlet Grille Panel Replacement
Disconnect the power vacuum brake booster vacuum sensor electrical connector.
- Remove the power vacuum brake booster vacuum sensor (1).
Clamp(1)@Power Brake Booster Vacuum Hose (2) - Release
- Power Brake Booster Vacuum Hose @ Power Brake Booster - Remove
Power Brake Booster Vacuum Hose Pass Through Grommet (1) - Release
- Warm Up Three-Way Catalytic Converter - Left Side - Remove - Warm Up Three-Way Catalytic Converter Replacement - Left Side (LGX)Warm Up Three-Way Catalytic Converter Replacement - Left Side (LTA)
Power Brake Booster Vacuum Hose Quick Connect Fitting (1) @ Vacuum Pipe - Release
- Power Brake Booster Vacuum Hose @ Vacuum Pipe - Remove