Removal Procedure
WARNING:
The battery must be disconnected to prevent the brake master cylinder from pressurizing the hydraulic system during its automated self diagnostic tests that can possibly occur when a door is opened or the key transmitter is activated. Failure to follow this precaution may cause personal injury.
WARNING:
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Engine Wiring Harness Fuse Block Bracket - Remove - Engine Wiring Harness Fuse Block Bracket Replacement (LGX)Engine Wiring Harness Fuse Block Bracket Replacement (LTA-Driver Side)Engine Wiring Harness Fuse Block Bracket Replacement (LTA-Passenger Side)
Brake Pipe Retainer (1) - Release
- Using a suitable tool, hold the brake union (2) stationary to prevent damage to the brake pipe.
- Brake Pipe Fitting (3) - Disconnect
- Plug the brake union (2) to prevent brake fluid loss and contamination.
- Raise and support the vehicle. Lifting and Jacking the Vehicle
Brake Pipe Retainer (1) - Release
- Remove the left front tire and wheel assembly. Tire and Wheel Removal and Installation
Brake Pipe Fitting (1) - Disconnect
- Cap the brake hose inlet fitting to prevent brake fluid loss and contamination.
- Brake Hose Retainer (2) - Disconnect
Brake Pipe (1) - Remove