LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2019 >> XTS Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 75 (Automatic Transmission - 6T70 (M7U M7W), 6T75 (M7V), Or 6T80 (Mhm) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Mount Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2018 Cadillac XTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM3232305Courtesy of GENERAL MOTORS COMPANY

    Install the left transmission mount (2).

  2. Loosely install NEW transmission mount to transmission bolts.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the transmission mount to frame rail fasteners (1) and tighten to 22 N.m (16 lb ft).
  4. Tighten the transmission mount to transmission bolts to 50 N.m (37 lb ft) plus 90 - 105 degrees
  5. If applicable, connect the wiring harness to the frame rail fastener stud.
  6. Install the range selector lever cable bracket. Range Selector Lever Cable Bracket Replacement 
scientia non olet · About LEMON Manuals