Engine Coolant Fan Shroud Replacement (LFX)

WARNING: This page is about a different car, the 2018 Cadillac XTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Engine Coolant Fan Shroud Component

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the intake manifold cover. Intake Manifold Cover Replacement (LFX)Intake Manifold Cover Replacement (LF3) Remove the front compartment front sight shield. Front Compartment Front Sight Shield Replacement Remove the front end upper tie bar. Front End Upper Tie Bar Replacement (With LF3)Front End Upper Tie Bar Replacement (Without LF3) Disconnect the engine coolant fan motor connectors. Reposition the electrical wiring harness.
1	Engine Coolant Fan Shroud Fastener (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 6 N.m (53 lb in)
2	Engine Coolant Fan Shroud Procedure Transfer all necessary parts.

Callout

Component Name

Preliminary Procedures

Remove the intake manifold cover. Intake Manifold Cover Replacement (LFX)Intake Manifold Cover Replacement (LF3)
Remove the front compartment front sight shield. Front Compartment Front Sight Shield Replacement
Remove the front end upper tie bar. Front End Upper Tie Bar Replacement (With LF3)Front End Upper Tie Bar Replacement (Without LF3)
Disconnect the engine coolant fan motor connectors.
Reposition the electrical wiring harness.

Engine Coolant Fan Shroud Fastener (Qty: 2)

CAUTION:

Refer to Fastener Caution .

Tighten
6 N.m (53 lb in)

Engine Coolant Fan Shroud
Procedure
Transfer all necessary parts.