Installation Procedure

Install the transmission range selector lever cable in the vehicle.
Courtesy of GENERAL MOTORS COMPANY

Connect the transmission range selector lever cable terminal (2) to the shift lever pin.
Install the transmission range selector cable to the transmission control base by pressing down until it seats into place.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Ensure the grommet is properly oriented.

Install the grommet and cable assembly (1) into the floor panel with alignment key opening.
Front Floor Lower Console Replacement - Install
Fig 1: Identifying Range Selector Lever Cable, Terminal, Shift Lever Pin And Retainer
Courtesy of GENERAL MOTORS COMPANY

WARNING:
After installing the transmission range selector shift cable, pull up and push down on ALL connections to verify that the connections are fully seated and properly engaged. Failure to perform this task can result in the vehicle not being able to shift into PARK causing potential vehicle damage and bodily injury.

Connect the transmission range selector lever cable terminal (1) to the transmission manual shift lever pin (6).
Install the cable into the bracket and ensure cable is fully seated.
Adjust the cable. Range Selector Lever Cable Adjustment .
{If equipped} Transmission Heat Shield - Install - Transmission Heat Shield Replacement