Front Cover Bolt Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Engine Front Cover Bolt Installation Components With Tightening Sequence (LGX)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Install the oil pan after the front cover installation. Oil Pan Installation (LGX AWD) , or Oil Pan Installation (LGX RWD) .
1	Engine Front Cover Bolt [2x] CAUTION: Refer to Fastener Caution . Tighten in sequence 15 N.m (11 lb ft)
2	Engine Front Cover Bolt [16x] Tighten in sequence 10 N.m (89 lb in)
3	Engine Front Cover Bolt NOTE: Part of engine mount on Front Wheel Drive version. Tighten in sequence 60 N.m (44 lb ft
4	Engine Front Cover Bolt NOTE: Part of engine mount on Front Wheel Drive version. Tighten in sequence 60 N.m (44 lb ft