Front Output Shaft Drive Sprocket Bearing Replacement
WARNING: This page is about a different variant/trim than selected.
Courtesy of GENERAL MOTORS COMPANY
| Callout |
Component Name |
|
Preliminary Procedure
- Using the J 35512
bearing installer and an arbor press, remove the bearing assemblies from the drive sprocket.
- Ensure the bearings are installed squarely into the drive sprocket bore.
- Install the bearings from the top with the clutch teeth facing down.
|
| 1 |
Transfer Case Front Output Shaft Drive Sprocket Bearing Assembly - Front Procedure
- Install the bearing using the long side of the DT-48211
bearing installer.
- Ensure the flat edge of the bearing is facing upward.
- Using an arbor press or hammer, install the bearing until the tool bottoms on the drive sprocket.
Special Tools
- DT-48211
Drive Sprocket Bearing Installer
- J 8092
Universal Driver
- J 35512
Inner Pinion Bearing Installer
For equivalent regional tools, refer to Special Tools . |
| 2 |
Transfer Case Front Output Shaft Drive Sprocket Bearing Assembly - Rear Procedure
- Install the bearing using the short side of the DT-48211
bearing installer.
- Ensure the flat edge of the bearing is facing upward.
- Using an arbor press or hammer, install the bearing until the tool bottoms on the drive sprocket.
Special Tools
- DT-48211
Drive Sprocket Bearing Installer
- J 8092
Universal Driver
- J 35512
Inner Pinion Bearing Installer
|