Drive Chain, Drive Sprocket And Driven Sprocket Cleaning And Inspection

WARNING: This page is about a different variant/trim than selected.

Fig 1: Drive Chain, Drive Sprocket, And Driven Sprocket Cleaning And Inspection Points

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Inspect all components or sub-components and perform any repair procedure necessary to fix the damage. If the damage cannot be repaired, replace the component or sub-component as indicated. Replace any components if damage is found in this procedure. The sprockets must be replaced as a pair. Clean all components in cleaning solvent and air dry.
1	Transfer Case Front Output Shaft Drive Sprocket Bearing Assembly Procedure Replace the bearings if roughness, brinelling, or pitting is detected. Refer to Front Output Shaft Drive Sprocket Bearing Replacement .
2	Transfer Case Front Output Shaft Drive Sprocket Bearing Bore NOTE: If the bearing is removed, inspect for excessive wear, damage or if the bearing has spun in the bore.
3	Transfer Case Four Wheel Drive Clutch Housing Engagement Teeth NOTE: Inspect the engagement teeth for chips or excessive wear.
4	Transfer Case Front Output Shaft Drive Sprocket NOTE: Inspect for chipped teeth, excessively worn gear surfaces, and debris embedded in the root of the teeth. Witness marks at the location of the chain is normal.
5	Transfer Case Front Output Shaft Driven Sprocket NOTE: Inspect for chipped teeth, excessively worn gear surfaces and debris embedded in the root of the teeth. Witness marks at the location of the chain is normal.
6	Transfer Case Front Output Shaft Drive Chain Assembly NOTE: Inspect for loose link pins, binding or stiff links, debris embedded in the links or worn teeth surfaces.