LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade ESV Platinum, RWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 5.3L (L83) Or 6.2L (L86) - Repair Instructions - Off Vehicle >> Repair Instructions - Off Vehicle >> Crankshaft Rear Oil Seal Housing Installation

Crankshaft Rear Oil Seal Housing Installation

Fig 1: Crankshaft Rear Oil Seal Housing (With Tightening Sequence)
GM2892262Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
1 Crankshaft Rear Oil Seal Housing Gasket
NOTE:

Must use a NEW gasket when installing the rear housing.
2 Crankshaft Rear Oil Seal Housing

Procedure

  1. Ensure proper use of room temperature vulcanizing (RTV) sealant. Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant
  2. Apply a 3 mm (0.118 in) bead of RTV sealant on the rear cover as shown (a). Apply a 5 mm (0.197 in) bead of RTV sealant on the rear cover as shown (b). Refer to Adhesives, Fluids, Lubricants, and Sealers for recommended sealant.
3 Crankshaft Rear Oil Seal Housing Bolt
CAUTION:

Refer to Fastener Caution .


Procedure 
Tighten the rear oil seal housing bolts in the sequence shown.
Tighten 
25 N.m (18 lb ft)
scientia non olet · About LEMON Manuals