| 1 |
Crankshaft Front Oil Seal Procedure
- Install EN-51096
crankshaft rear seal remover onto GE-23907-1
slide hammer.
NOTE:
EN-51096
crankshaft rear seal remover has two ends. The end with the small bend will be used to remove the seal.
- Slide the small bend of EN-51096
crankshaft rear seal remover between the lip of the front seal and crankshaft. Ensure that the small bend of EN-51096
crankshaft rear seal remover engages the rear side of the front seal (1). While rotating EN-51096
crankshaft rear seal remover and GE-23907-1
slide hammer around the seal, use the slide hammer to remove the seal.
Special Tools
- EN-51096
Crankshaft Rear Seal Remover
- GE-23907-1
Slide Hammer
For equivalent regional tools, refer to Special Tools
. |