LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Engine Mechanical - 6.0L (L96)) >> Repair Instructions - On Vehicle >> Cylinder Head Replacement - Right Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Negative Battery Cable Terminal, Engine Harness Terminal And Stud
    GM1699543Courtesy of GENERAL MOTORS COMPANY
  1. Remove the oil level indicator. Refer to Oil Level Indicator Tube Replacement .
  2. Remove the intake manifold. Refer to Intake Manifold Replacement .
  3. Remove the coolant air bleed pipe. Refer to Engine Coolant Air Bleed Pipe Replacement (L96) .
  4. Remove the right exhaust manifold. Refer to Exhaust Manifold Replacement - Right Side (L96) .
  5. Remove the pushrods. Refer to Valve Rocker Arm and Push Rod Replacement .
  6. Remove the negative battery cable stud (1) from the front of the right cylinder head.
  7. Remove the negative battery cable terminal (2) and the engine harness terminal (3) from the cylinder head.
    8. Fig 2: Cylinder Head And Bolts
    GM3632859Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The cylinder head bolts are of a torque-to-yield design and are NOT to be reused.

  8. Remove and discard the cylinder head bolts (1, 2).
    9. CAUTION:

    After removal, place the cylinder head on 2 wood blocks in order to prevent damage to the sealing surfaces.

  9. Remove the cylinder head (3).
    10. Fig 3: Cylinder Head Gasket
    GM3632942Courtesy of GENERAL MOTORS COMPANY
  10. Remove and discard the cylinder head gasket (1).
  11. If required, clean and inspect the cylinder head. Refer to Cylinder Head Cleaning and Inspection .
scientia non olet · About LEMON Manuals