LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> Escalade Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Transfer Case - Mp 3010 (NP0)) >> Repair Instructions - Off Vehicle >> Transfer Case Assemble >> Rear Output Shaft Seal and Bushing Installation

Rear Output Shaft Seal and Bushing Installation

WARNING: This page is about a different car, the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, and 2018 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Output Shaft Seal and Bushing
GM2236735Courtesy of GENERAL MOTORS COMPANY
Rear Output Shaft Seal and Bushing Installation

Callout Component Name
1 Transfer Case Rear Output Shaft Bushing

Procedure

  1. Follow the steps for use of the J-45380  remover/installer.
  2. Install the bushing on the finger section of the J-45380  remover/installer.
  3. Install the finger section to the main body of the J-45380  remover/installer.
  4. Position the bushing and tool to the rear case half.
  5. Press the bushing until the tool bottoms on the rear case half.
NOTE:
  • If the bushing was removed, a new bushing must be installed.
  • Ensure the bushing is installed squarely into the bushing bore.

Special Tools 
J-45380  Transfer Case Rear Bushing Remover and Installer
2 Transfer Case Rear Output Shaft Seal
NOTE: Align the notch on the seal between the rear output bearing retaining ring access holes, this will position the weep hole down.

Special Tools

  • DT-48210  Seal Installer
  • J-8092  Driver Handle

Equivalent regional tools: Special Tools 
scientia non olet · About LEMON Manuals