LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2018 >> CTS Base, AWD >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat Hardware, Seat Trim, And Upholstery >> Repair Instructions >> Driver or Passenger Seat Removal and Installation

Driver or Passenger Seat Removal and Installation

GM2809702Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
WARNING:

Refer to SIR Warning .

Preliminary Procedure

  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Disconnect the seat belt from the tensioner. Refer to Front Seat Belt Anchor Plate Tensioner Replacement .
  3. Remove the driver or passenger seat inner adjuster front finish cover. Refer to Driver or Passenger Seat Inner Adjuster Front Finish Cover Replacement .
  4. Remove the driver or passenger seat outer adjuster front finish cover. Refer to Driver or Passenger Seat Outer Adjuster Front Finish Cover Replacement (Rear) Driver or Passenger Seat Outer Adjuster Front Finish Cover Replacement (Front) .
  5. Remove the front seat cushion front finish cover. Refer to Front Seat Cushion Front Finish Cover Replacement .
1 Driver or Passenger Seat Bolt (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Procedure 
Adjust the seat to the forward position to gain access to the rear bolts.
Tighten 
45 N.m (33 lb ft)
2 Driver or Passenger Seat Assembly

Procedure

  1. Disconnect the front seat and tensioner electrical connector, and passenger presence system connector, if equipped.
  2. With the aid of an assistant remove the front seat, by tilting the seat forward, and then lifting and pulling the seat rearwards to disengage the 4 front foot hooks.
  3. If replacing with a new seat assembly, the new seat adjuster memory module requires programming. Refer to Control Module References
scientia non olet · About LEMON Manuals