Intake Manifold Replacement (LGX)

WARNING: This page is about a different variant/trim than selected.

Fig 1: Intake Manifold Replacement (LGX)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Air Cleaner Outlet Duct Replacement (LF3)Air Cleaner Outlet Duct Replacement (LGX) Detach positive crankcase ventilation tube retainer from intake manifold. Disconnect and reposition the EVAP purge tube. Plastic Collar Quick Connect Fitting Service Disconnect the electrical connectors. Fuel Pipe Shield Replacement (LF3)Fuel Pipe Shield Replacement (LGX)
1	Intake Manifold Bolt CAUTION: Refer to Fastener Caution . Tighten in sequence 25 N.m (18 lb ft)
2	Intake Manifold Procedure Transfer components as necessary. Intake Manifold Disassemble (LF3)Intake Manifold Disassemble (LGX) , and Intake Manifold Assemble (LF3)Intake Manifold Assemble (LGX) NOTE: Install NEW gaskets.

Callout

Component Name

Preliminary Procedures

Intake Manifold Bolt

CAUTION:

Tighten in sequence
25 N.m (18 lb ft)

NOTE:

Install NEW gaskets.