Rear Window Panel Trim Replacement (With DB3)

WARNING: This page is about a different car, the 2016 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Window Panel Trim (With DB3)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Lower the rear compartment rear window lower trim to access the retainers through the rear compartment. Refer to Rear Compartment Rear Window Lower Trim Replacement Remove the body side rear window garnish molding. Refer to Body Side Rear Window Garnish Molding Replacement .
1	Rear Window Panel Trim Fastener (Qty: 3) CAUTION: Refer to Fastener Caution . Tighten 9 N.m (80 lb ft)
2	Rear Window Panel Trim Push-In Fastener (Qty: 3) Procedure Fold down the rear seats to access the retainers.
3	Rear Window Panel Trim Assembly Procedure With the aid of an assistant, guide the rear window panel forward in the vehicle and upwards to clear the speaker system. Route the rear seat belt bracket cover and center seat belt through the rear window trim panel opening. Disconnect the electrical connector. When replacing the rear window panel trim assembly, transfer all necessary components.