LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2016 >> SRX Performance, AWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 3.0L (LFW) Or 3.6L (LFX) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Oil Pan Replacement >> Installation Procedure

Installation Procedure

  1. Assemble the oil pan. Refer to Oil Pan Assemble .
  2. Fig 1: Guide Pin Set
    GM1306197Courtesy of GENERAL MOTORS COMPANY
  3. Install the 8 mm (0.315 in) guides from the EN-46109  guide pin set into the center oil pan rail bolt hole on each side of the engine block.
  4. Fig 2: Sealant Application Locations On Block Pan Rail & Crankshaft Rear Oil Seal Housing
    GM1306200Courtesy of GENERAL MOTORS COMPANY
  5. Place a 3 mm (0.118 in) bead (1) of RTV sealant, on the block pan rail and the crankshaft rear oil seal housing.
  6. Fig 3: Oil Pan
    GM1829127Courtesy of GENERAL MOTORS COMPANY
  7. Position the oil pan onto the block.
  8. Fig 4: Guide Pin Set
    GM1829130Courtesy of GENERAL MOTORS COMPANY
  9. Remove the EN-46109  set 8 mm (0.315 in) guides from the engine block.
  10. Fig 5: Locating Oil Pan Bolts
    GM1829119Courtesy of GENERAL MOTORS COMPANY
  11. Loosely install the oil pan bolts.
  12. Fig 6: Oil Pan Bolt Tightening Sequence
    GM1829133Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  13. Tighten the oil pan bolts in sequence.
    1. The 8 mm bolts (1-11) to 25 N.m (18 lb ft).
    2. The 6 mm bolts (12, 13) to 10 N.m (89 lb in).
  14. Install engine front cover. Refer to Engine Front Cover Replacement .
  15. Reposition the air conditioning (A/C) compressor and install the bolts. Refer to Air Conditioning Compressor Replacement (LFX) .
  16. Install the catalytic converter. Refer to Catalytic Converter Replacement - Left Side (Front) .
  17. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
  18. Refill the engine oil. Refer to Engine Oil and Oil Filter Replacement (LF1, LFW or LFX) .