|
Preliminary Procedures
- Remove the windshield wiper system module. Refer to Windshield Wiper System Module Replacement
.
- Remove the front compartment side sight shields. Refer to Front Compartment Side Sight Shield Replacement
- Remove the left and right hand plenum side panel. Refer to Plenum Side Panel Replacement - Left Side and Plenum Side Panel Replacement - Right Side
- Remove the left or right hand hood strut. Refer to Hood Strut Replacement (CTS) and Hood Strut Replacement (CTS-V)
|
| 1 |
Diagonal Brace to Plenum Bolt (Qty 2)
Tighten
22 N.m (16 lb ft) |
| 2 |
Plenum Front Panel Bolt (Qty: 5)
Tighten
9 N.m (80 lb in) |
| 3 |
Plenum Front Panel Nut (Qty: 6)
Tighten
9 N.m (80 lb in) |
| 4 |
Plenum Front Panel Procedure
- Remove the electrical harness grommet from the panel.
- Ensure all seals are in place before installation.
- Reposition the wiring harness and harness retainers.
|