Driver or Passenger Seat Back Cushion Latch Release Handle Replacement (Coupe)

Fig 1: Seat Back Cushion Latch Release Handle (Coupe)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
WARNING: Refer to SIR Warning . Preliminary Procedure Disable the SIR system. Refer to SIR Disabling and Enabling Remove the driver or passenger seat back cushion finish panel. Refer to Front Seat Back Cushion Finish Panel Replacement (W2E) Front Seat Back Cushion Finish Panel Replacement (AQ9) Rear Seat Replacement
1	Front Seat Back Cushion Latch Release Handle Procedure Lift up the release handle to gain access to the tabs. Gently push outboard on the tabs located on the handle. Pull the handle rearward to disengage the handle from the latch assembly.
2	Front Seat Back Cushion Latch Release Handle Bezel Procedure Gently remove the handle bezel by pulling rearward near the retainer clip locations.
3	Front Seat Back Cushion Latch Release Handle Fastener (Qty: 2)
4	Front Seat Back Cushion Latch Release Handle Procedure Disconnect the cushion release latch cable. Disconnect the electrical connector. Disengage the latch assembly by sliding the latch inboard to remove it from the seat back frame.