LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2015 >> CTS V, Automatic Trans >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System (Coupe) >> Repair Instructions >> Inflatable Restraint Passenger Presence System Replacement - Front

Inflatable Restraint Passenger Presence System Replacement - Front

Fig 1: Inflatable Restraint Passenger Presence System - Front
GM1969509Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedure

  1. Remove the front seat. Refer to Front Seat Removal and Installation - Bucket (AQ9)Front Seat Removal and Installation - Bucket (W2E) .
  2. Remove the seat cushion cover. Refer to Front Seat Cushion Cover and Pad Replacement (W2E)Front Seat Cushion Cover and Pad Replacement (AQ9) .
1 Inflatable Restraint Front Passenger Presence System Assembly
WARNING:

Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. All the components in the service kit are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly.

WARNING:

To avoid personal injury, perform a preload test on the passenger presence system whenever you remove or replace the seat cushion trim. Failure to do so may cause the system to malfunction.

Procedures

  1. Preload Test the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Control Module References .
  2. Program the inflatable restraint passenger presence system after replacement. Refer to Control Module References .
  • The passenger presence system is an integral part of the pad on the passenger seat cushion.
  • The sensor, module and seat cushion pad must be replaced as a unit.
  • Note the routing of the wiring harness and connector location for installation.
scientia non olet · About LEMON Manuals