LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2015 >> CTS V, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Engine Controls And Fuel - 6.2L (LSA) - Repair Instructions (Coupe) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

  1. Remove the exhaust system. Refer to Exhaust System Replacement .
  2. Steps 3-5 apply to Sedan/Wagon only. Proceed to step 6 for Coupe.
  3. Place a jack stand under the rear differential assembly.
    4. Fig 1: View of Front Differential Mounting Bolts
    GM1970358Courtesy of GENERAL MOTORS COMPANY
  4. Remove the two front differential mounting bolts (1).
  5. Lower the differential slightly to provide additional clearance to the Evap canister.
  6. Remove the two EVAP canister retaining nuts and lower the rear of the canister enough to clear the weld studs.
  7. Slide the canister rearward from the body brace to gain access to the canister vent valve.
  8. Clean away any debris that may be present around the EVAP canister vent valve.
  9. Disconnect the electrical connector from the EVAP canister vent valve.
    10. Fig 2: View Of EVAP Canister Vent Valve
    GM827315Courtesy of GENERAL MOTORS COMPANY
  10. Twist the EVAP canister vent valve counterclockwise.
  11. Pull the EVAP canister vent valve from the EVAP canister.
scientia non olet · About LEMON Manuals