Installation Procedure

Fig 1: View Of EVAP Canister Vent Valve

Courtesy of GENERAL MOTORS COMPANY

Insert the EVAP canister vent valve into the EVAP canister.
Twist the EVAP canister vent valve clockwise into the locked position.
Connect the electrical connector to the EVAP canister vent valve.
Attach the EVAP canister to the body by inserting the fresh air tube and tab on the canister forward into the body brace.
Rotate the rear of the canister up over the 2 weld studs on the floor pan.
Install the EVAP canister to the body and install the bolts and tighten to 6 (53 lb in).

Fig 2: View of Front Differential Mounting Bolts

Courtesy of GENERAL MOTORS COMPANY

Sedan/Wagon only: Raise the rear differential into position and install the front mounting bolts (1)and tighten to 175 (129 lb ft).
Install the exhaust system. Refer to Exhaust System Replacement .