LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2014 >> XTS Livery >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Engine Controls And Fuel - 3.6L (LFX LF3) - Repair Instructions >> Repair Instructions >> Ignition Coil Replacement - Bank 2 (LF3) >> Installation Procedure

Installation Procedure

    Fig 1: Ignition Coils
    GM3331356Courtesy of GENERAL MOTORS COMPANY
  1. Install the ignition coil(s) (2).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the ignition coil bolt(s) (1).

    Tighten 

    the bolt(s) to 10 (89 lb in)

    3. Fig 2: Engine Wiring Harness Electrical Connector(s)
    GM3331367Courtesy of GENERAL MOTORS COMPANY
  3. Connect the engine wiring harness electrical connector(s) (1) to the ignition coil(s) (2).
  4. For cylinder #4, install the charge air cooler inlet pipe (left). Refer to Charge Air Cooler Inlet Pipe Replacement - Left Side (LF3) .
scientia non olet · About LEMON Manuals