LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls/Fuel - Hybrid (LZ1) - Repair Instructions) >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Accelerator Pedal Position Sensor Assembly
    GM1704147Courtesy of GENERAL MOTORS COMPANY
  1. Position the accelerator pedal to the accelerator pedal bracket.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the accelerator pedal bolts.

    Tighten 

    Tighten the bolts to 9 N.m (80 lb in).

    3. Fig 2: View Of APP Sensor Electrical Connector
    GM1704152Courtesy of GENERAL MOTORS COMPANY
  3. Connect the APP sensor electrical connector (1).
  4. Connect a scan tool to the diagnostic port in order to test for proper throttle-opening and throttle-closing range.
  5. Operate the accelerator pedal and monitor the throttle angles. The accelerator pedal should operate freely, without binding, between a closed throttle, and a wide open throttle (WOT).
  6. Verify that the vehicle meets the following conditions:
    • The vehicle is not in a reduced engine power mode.
    • The ignition is ON.
    • The engine is OFF.
  7. Install the knee bolster. Refer to Knee Bolster Replacement (Except Cadillac) , Knee Bolster Replacement (Cadillac) .
scientia non olet · About LEMON Manuals