Repair Instructions
WARNING: This page is about a different car, the 2013 GMC Yukon XL, 2013 GMC Yukon, 2013 Chevrolet Tahoe, 2013 Chevrolet Suburban, and 2013 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
- Control Module References for TCSCM replacement, setup, and programming
- Transfer Case High/Low Clutch Reset
- Transfer Case Two/Four Wheel Drive Actuator Replacement
- Transfer Case Disassemble
- Transfer Case Assemble
- Oil Pump Cleaning and Inspection
- Rear Output Shaft Cleaning and Inspection
- Front Output Shaft and Input Shaft Cleaning and Inspection
- Drive Chain, Drive Sprocket, and Driven Sprocket Cleaning and Inspection
- High/Low Shift Components Cleaning and Inspection
- Two/Four Wheel Drive Shift Components Cleaning and Inspection
- Transfer Case Front Half Cleaning and Inspection
- Transfer Case Rear Half Cleaning and Inspection