Rear Quarter Trim Panel Replacement - Right Side (Standard Wheelbase)

Preliminary Procedures

1. Disable the roof rail SIR system. Refer to SIR Disabling and Enabling .
2. Remove the third row folding seat if equipped. Refer to 3rd Row Seat Removal and Installation (Suburban/Yukon XL) , 3rd Row Seat Removal and Installation (Tahoe/Yukon/Escalade) .
3. Remove the rear opening garnish molding. Refer to Rear Door Upper Garnish Molding Replacement .
4. Remove the back rear corner upper garnish molding. Refer to Body Rear Corner Garnish Molding Replacement - Right Side .
5. Remove the rear side door sill plate. Refer to Rear Side Door Sill Trim Plate Replacement (Extended Wheelbase) , Rear Side Door Sill Trim Plate Replacement (Standard Wheelbase) .
6. Remove the body side lock pillar garnish molding. Refer to Body Lock Pillar Garnish Molding Replacement (Standard Wheelbase) , Body Lock Pillar Garnish Molding Replacement (Avalanche/Escalade EXT) , Body Lock Pillar Garnish Molding Replacement (Extended Wheelbase) .

1. Align the 4-way locator to the body side inner and then the 2-way locator to the body back opening.
2. Disconnect the electrical connector.