Body Lock Pillar Garnish Molding Replacement (Standard Wheelbase)

Fig 1: View Of Body Lock Pillar Garnish Molding Assembly & Components

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Disable the roof rail SIR system. Refer to SIR Disabling and Enabling . Remove the rear side door sill plate. Refer to Rear Side Door Sill Trim Plate Replacement (Extended Wheelbase) , Rear Side Door Sill Trim Plate Replacement (Standard Wheelbase) . Fold the rear seat up and forward. Reposition the rear side door weatherstrip off the molding.
1	Body Lock Pillar Garnish Molding Plug
2	Body Lock Pillar Garnish Molding Screw CAUTION: Refer to Fastener Caution . Tighten 2 N.m (18 lb in)
3	Body Lock Pillar Garnish Molding Assembly Tighten 35 N.m (25 lb ft) If equipped with rear folding seat, disconnect the electrical connectors. Remove seat belt D-ring from the adjuster assembly. Route seat belt through garnish molding.
4	Body Lock Pillar Garnish Molding Clip (Qty: 10)