LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 4.6L (LH2) - Repair Instructions - On Vehicle - 1 Of 2) >> Engine Mount Bracket Replacement - Right Side (with AWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Right Engine Mount Bracket - AWD
    GM888300Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount bracket to the vehicle.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the engine mount bracket mounting bolts and tighten to 60 N.m (44 lb ft).
  3. Remove the screw jack.
    4. Fig 2: Right Engine Mount & Upper Retaining Nut - AWD
    GM888294Courtesy of GENERAL MOTORS CORP.
  4. Install the upper engine mount retaining nut and tighten to 80 N.m (59 lb ft).
  5. Install the right exhaust manifold. Refer to Exhaust Manifold Removal - Right Side (RWD) or Exhaust Manifold Removal - Right Side (AWD) .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals