LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Hood Primary Latch Release Cable Replacement >> Removal Procedure

Removal Procedure

  1. Open the hood.
  2. Remove the hood latch. Refer to Hood Primary and Secondary Latch Replacement 
  3. Disconnect the hood release cable from the hood latch.
  4. Tie a piece of string around the hood release cable. This will ease the installation of the hood release cable through the engine compartment.
    5. Fig 1: Hood Release Handle & Fasteners
    GM714080Courtesy of GENERAL MOTORS CORP.
  5. Remove the fasteners (3) securing the hood release handle (1) to the vehicle.
    6. Fig 2: Hood Release Cable & Handle
    GM714073Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the hood release cable (2) from the hood release handle (1).
    7. Fig 3: Hood Release Cable
    GM1435928Courtesy of GENERAL MOTORS CORP.
  7. Tie a piece of string around the hood release cable (1). This will ease the installation of the hood release cable through the engine compartment.
  8. Remove the hood release cable grommet from the wheel opening.
  9. Remove the hood release cable (1) from the vehicle.
scientia non olet · About LEMON Manuals