LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2010 >> STS 3.6 V, AWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Hood Primary Latch Release Cable Replacement >> Installation Procedure

Installation Procedure

  1. Transfer the string to either end of the new hood release cable.
  2. Route the string and the hood release cable into the passenger compartment.
  3. Remove the string from the hood release cable.
  4. Seat the hood release cable grommet into the wheel opening.
    5. Fig 1: Hood Release Cable & Handle
    GM714073Courtesy of GENERAL MOTORS CORP.
  5. Connect the hood release cable (2) to the hood release handle (1).
    6. Fig 2: Hood Release Handle & Fasteners
    GM714080Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  6. Install the fasteners (3) in order to secure the hood release handle (1) to the vehicle. Tighten the fasteners to 2 N.m (18 lb in).
    7. Fig 3: Hood Release Cable
    GM1435928Courtesy of GENERAL MOTORS CORP.
  7. Pull the string and the hood release cable (1) through the engine compartment.
  8. Remove the string from the hood release cable (1).
  9. Connect the hood release cable (1) to the hood latch.
  10. Install the hood latch. Refer to Hood Primary and Secondary Latch Replacement 
  11. Close the hood.
scientia non olet · About LEMON Manuals