LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> STS V >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Front Side Door Wiring Harness Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Locating Front Door Wiring Harness
    GM776567Courtesy of GENERAL MOTORS CORP.
  1. Remove the door trim panel. Refer to Rear Side Door Trim Panel Replacement .
  2. Remove the door control module. Refer to Door Control Module Replacement .
  3. Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .
  4. Remove the door wire harness connector from the pillar by inserting a small flat bladed tool between the connector and the pillar and depress the retaining tabs on the connector.
  5. Disconnect the door wire harness from the body wire harness.
  6. Disconnect the door latch electrical connector.
  7. Disconnect the power window motor electrical connector.
  8. Disconnect the wiring harness rosebud retainers (1) from the inner front door panel.
  9. Push the wiring harness rubber grommet (2) into the door.
  10. Remove the grommet (3) from the door inner panel.
  11. Remove the wiring harness from the door.
scientia non olet · About LEMON Manuals