Torque Converter Housing with Fluid Pump Installation

Fig 1: View Of Torque Converter Housing & Fluid Pump Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .
1	NEW Fluid Pump Seal
2	Torque Converter (with Fluid Pump) Housing Assembly NOTE: Ensure the turbine shaft (O-ring) seal is not installed prior to installing the torque converter housing assembly. The seal may become cut or damaged during installation of the torque converter housing assembly.
3	Bolts M10 x 50 (Quantity: 9) Tighten: Tighten to 72 N.m (53 lb ft) in the sequence shown.
4	NEW Turbine Shaft (O-Ring) Seal