Fluid Pump Cover Installation

Fig 1: View Of Fluid Pump Cover Assembly, Cover Bolt Tightening Sequence, 1-2-3-4 & 3-5 Reverse Clutch Housing Thrust Washer & Alignment Tool

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .
1	Fluid Pump Cover Assembly
2	Fluid Pump Cover Bolts M6 x 40 (Quantity: 13) Tip: Hand tighten only.
3	Alignment Tool and Bolt Tip: Center the J 46664 around the fluid pump cover assembly in the 9 o'clock position and tighten the alignment bolt. See Special Tools . Tighten the fluid pump cover bolts in the sequence shown. Tighten: Tighten to 11 N.m (97 lb in) Special Tool: J 46664 Pump Cover Alignment Tool. See Special Tools .
4	NEW 1-2-3-4 and 3-5 Reverse Clutch Housing Thrust Washer