Control Valve Body Assembly Installation
Control Valve Body Assembly Installation
| Callout | Component Name |
|---|---|
|
NOTE:
Refer to Fastener Notice
. Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . |
|
| 1 | NEW Fluid Pump Seal Assembly |
| 2 | NEW Fluid Pump Seal Assembly |
| 3 | NEW Center Support Fluid Passage Seal Assembly |
| 4 | Control Valve Body Assembly Tip: Align the manual shift shaft position switch activator slide with the detent lever guide pin. |
| 5 | Bolts M5 x 73 (Quantity: 6) Tighten: Tighten to 8 N.m (71 lb in) in the sequence shown. |