LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> Escalade RWD >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 6L50/6L80/6L90 - Introduction (2 Of 2) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Control Valve Body Assembly Assemble >> Control Solenoid Valve Assembly Contact Gap Inspection

Control Solenoid Valve Assembly Contact Gap Inspection

Fig 1: Inspecting Control Solenoid Valve Assembly Contact Gap
GM1681608Courtesy of GENERAL MOTORS CORP.
Control Solenoid Valve Assembly Contact Gap Inspection

Callout Component Name
1 Control Solenoid (w/Body and TCM) Valve Assembly
Tip:  Inspect the contact area between the "heat sink" area of the control solenoid valve assembly and the valve body. There should be no visible gap. If a gap exists, loosen all 18 bolts and retighten in the required sequence.
scientia non olet · About LEMON Manuals