3-5 and Reverse Clutch Plate Installation
3-5 and Reverse Clutch Plate Installation
| Callout | Component Name |
|---|---|
| 1 | 3-5 Reverse Clutch Apply Ring
NOTE:
Ensure apply ring legs are positioned into the 3-5 reverse clutch piston. Failure to do so may cause damage to the 3-5 reverse clutch assembly.
|
| 2 | 3-5 Reverse Clutch (Waved) Plate |
| 3 | 3-5 Reverse Clutch Plate (Quantity: 4) |
| 4 | 3-5 Reverse Clutch Plate Assembly (Quantity: 4) |
| 5 | 3-5 Reverse Clutch Backing Plate |
| 6 | 3-5 Reverse Clutch Backing Plate Retaining Ring
NOTE:
Align the retaining ring gap with the missing snap ring groove punch in the housing. Failure to do so may cause damage to the clutch assembly. Tip: After the retaining ring is installed, determine clutch piston travel in order to verify if the correct selective retaining ring is being used. Refer to 3-5 Reverse Clutch Backing Plate Retaining Ring Measurement . |