Trim Panel Replacement - Rear Quarter - Right (Standard Wheelbase)

Preliminary Procedures

1. Disable the roof rail SIR system. Refer to SIR Disabling and Enabling .
2. Remove the third row folding seat if equipped. Refer to Rear Number 2 Seat Replacement (Suburban/Yukon XL) or Rear Number 2 Seat Replacement (Tahoe/Yukon/Escalade) .
3. Remove the rear opening garnish molding. Refer to Garnish Molding Replacement - Rear Door Upper .
4. Remove the back rear corner upper garnish molding. Refer to Garnish Molding Replacement - Rear Corner (Tahoe/Suburban) .
5. Remove the rear side door sill plate. Refer to Rear Side Door Sill Plate Replacement (Extended Wheelbase)  or Rear Side Door Sill Plate Replacement (Standard Wheelbase) .
6. Remove the body side lock pillar garnish molding. Refer to Body Lock Pillar Garnish Molding Replacement (Avalanche/Escalade EXT)  or Body Lock Pillar Garnish Molding Replacement (Suburban/Yukon XL/Escalade ESV)  or Body Lock Pillar Garnish Molding Replacement (Tahoe/Yukon/Escalade) .

1. Align 4-way locator to body side inner and then 2-way locator to body back opening.
2. Disconnect electrical connector.