Seat Cushion Trim Cover and Pad Replacement (with HP2)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Seat Cushion Trim Cover & Pad (With HP2)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the front seat. Refer to Front Seat Replacement - Bucket (without HP2) , Front Seat Replacement - Bucket (with HP2) . Remove the front seat cushion outer trim panel. Refer to Front Seat Cushion Outer Trim Panel Replacement (with HP2) , Front Seat Cushion Outer Trim Panel Replacement (Manual Seat without HP2) , Front Seat Cushion Outer Trim Panel Replacement (Power Seat without HP2) . Remove the front seat cushion inner trim panel. Refer to Front Seat Cushion Inner Trim Panel Replacement (without HP2) , Front Seat Cushion Inner Trim Panel Replacement (with HP2) .
1	Front Seat Cushion Cover Procedure Disengage the j-channel retainers from the seat cushion frame. Remove the hog rings. Tilt the seat back forward to make it easier to remove and install the cover. Disconnect the electrical connectors that attach to the seat cushion, if equipped. Remove the seat cushion cover and pad from the seat cushion frame as an assembly. Pull the cover away from the pad to disengage the hog rings.
2	Front Seat Cushion Pad Procedure If working on the passenger seat, re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Control Module References .

Callout

Component Name

Preliminary Procedures

Remove the front seat. Refer to Front Seat Replacement - Bucket (without HP2) , Front Seat Replacement - Bucket (with HP2) .
Remove the front seat cushion outer trim panel. Refer to Front Seat Cushion Outer Trim Panel Replacement (with HP2) , Front Seat Cushion Outer Trim Panel Replacement (Manual Seat without HP2) , Front Seat Cushion Outer Trim Panel Replacement (Power Seat without HP2) .
Remove the front seat cushion inner trim panel. Refer to Front Seat Cushion Inner Trim Panel Replacement (without HP2) , Front Seat Cushion Inner Trim Panel Replacement (with HP2) .

Front Seat Cushion Cover

Procedure

Disengage the j-channel retainers from the seat cushion frame.
Remove the hog rings.
Tilt the seat back forward to make it easier to remove and install the cover.
Disconnect the electrical connectors that attach to the seat cushion, if equipped.
Remove the seat cushion cover and pad from the seat cushion frame as an assembly.
Pull the cover away from the pad to disengage the hog rings.

Front Seat Cushion Pad
Procedure
If working on the passenger seat, re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Control Module References .