LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1956 (Seat Hardware, Seat Trim, And Upholstery) >> Repair Instructions >> Front Seat Cushion Outer Trim Panel Replacement (with HP2)

Front Seat Cushion Outer Trim Panel Replacement (with HP2)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Front Seat Cushion Outer Trim Panel Components (With HP2)
GM1960368Courtesy of GENERAL MOTORS COMPANY
Front Seat Cushion Outer Trim Panel Replacement (with HP2)

Callout Component Name

Preliminary Procedures

  1. Disconnect the lower portion of the seat back finish panel from the seat frame and lift upward to gain access to the screws.
  2. Remove the front seat lumbar actuator knob, if equipped. Refer to Driver or Passenger Seat Lumbar Support Actuator Knob Replacement (with HP2) , Driver or Passenger Seat Lumbar Support Actuator Knob Replacement (without HP2) .
  3. Remove Recliner Handle If equipped. Refer to Driver or Passenger Seat Recliner Handle Replacement (without HP2) , Driver or Passenger Seat Recliner Handle Replacement (with HP2) 
1 Front Seat Cushion Outer Finish Panel Cover Screw (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
2 Front Seat Cushion Outer Finish Panel Cover

Procedure

  1. Disengage the outer trim cover from the inner recliner cover.
  2. Pull outward to disengage the retainer clips.
  3. Pull finish panel in middle to remove from lumbar knob area.
  4. Slide front edge of finish panel forward to disengage from bracket.
  5. Disconnect the seat switch electrical connector.
  6. If replacing the cover, transfer necessary components.
scientia non olet · About LEMON Manuals