Rear Bumper Fascia Replacement (All Utility, Cadillac ESV)
Rear Bumper Fascia Replacement (All Utility, Cadillac ESV)
| Callout | Component Name |
|---|---|
| Preliminary Procedure: Remove the rear wheelhouse inner panel extensions. Refer to Wheelhouse Liner Panel Replacement - Rear . |
|
| 1 | Rear Fascia Bolts (Qty: 2)
NOTE:
Refer to Fastener Notice
.
Tighten: 9 N.m (80 lb in) |
| 2 | Rear Fascia Plastic Bolts (Qty: 4) Tip: Disconnect the rear object detection sensor harness located in the right end of the fascia and any other electrical connectors before attempting removal. Tighten: 9 N.m (80 lb in) |
| 3 | Rear Fascia Bolts (Qty: 4) Tighten: 9 N.m (80 lb in) |
| 4 | Rear Fascia Plastic Retainers (Qty: 2) |
| 5 | Fascia Assembly Tip: If replacing the Z-71 fascia then new fender flare holes will need to be drilled as needed. |