Knee Bolster Replacement (without RPO SLT)

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Knee Bolster Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the park brake release handle assembly from the knee bolster. Refer to Parking Brake Release Handle Assembly Replacement .
1	Instrument Panel Left Outer Trim Cover Refer to Instrument Panel Outer Trim Cover Replacement (without RPO SLT) or Instrument Panel Outer Trim Cover Replacement (with RPO SLT) .
2	Knee Bolster Screw (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
3	Knee Bolster Assembly Tip: Disconnect the electrical connectors. If replacing the knee bolster assembly, transfer all necessary components.
4	Retainer Clip (Qty: 3)