Low Engine Oil Level Indicator Inoperative

Step	Action	Yes	No
Schematic Reference: Instrument Cluster Schematics Connector End View Reference: Engine Control Module Connector End Views for the 4.6L engine or Engine Control Module Connector End Views for the 4.4L engine
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Turn ON the ignition. With the scan tool, observe the Engine Oil Level Switch parameter in the engine control module (ECM) data list. Does the Engine Oil Level Switch parameter display OK?	Go to Testing for Intermittent Conditions and Poor Connections	Go to Step 3
3	Replace the instrument panel cluster (IPC). Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement?	Go to Step 4	-
4	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2