LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 4.6L (LH2) - 1 Of 5) >> On-Vehicle Repair Instructions (Part 1) >> Engine Mount Bracket Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Left Engine Mount Bracket
    GM888296Courtesy of GENERAL MOTORS CORP.
  1. Install the left engine mount brackets.
    2. NOTE: Refer to Fastener Notice .
  2. Install the left engine mount bracket retaining bolts.

    Tighten:  Tighten the bolts to 60 N.m (44 lb ft).

    3. Fig 2: View Of Left Engine Mount
    GM888298Courtesy of GENERAL MOTORS CORP.
  3. Install the upper engine mount retaining nut.

    Tighten:  Tighten the nut to 80 N.m (59 lb ft).

  4. Remove the screw jack.
  5. Install the left exhaust manifold. Refer to Exhaust Manifold Removal - Left Side .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals