LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System - 4.4L - Introduction (2 Of 2)) >> Repair Instructions >> Supercharger Inlet Absolute Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: BARO, MAP & SCIAP Sensors
    GM1613998Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition OFF.
  2. Remove the engine sight shield. Refer to Intake Manifold Sight Shield Replacement .
  3. Disconnect the supercharger inlet absolute pressure (SCIAP) sensor (1) electrical connector.
    4. Fig 2: Vacuum Line Fitting
    GM1614007Courtesy of GENERAL MOTORS CORP.
  4. Remove the SCIAP sensor from the bracket.
  5. Disconnect the vacuum line fitting (2) from the bottom of the SCIAP sensor.
  6. Inspect the SCIAP sensor vacuum line and fittings (1, 2) for leaks.
scientia non olet · About LEMON Manuals