LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System - 4.4L - Introduction (2 Of 2)) >> Repair Instructions >> Supercharger Inlet Absolute Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Vacuum Line Fitting
    GM1614007Courtesy of GENERAL MOTORS CORP.
  1. Connect the vacuum line fitting (2) to the port on the bottom of the SCIAP sensor.
  2. Install the SCIAP sensor to the bracket.
    3. Fig 2: BARO, MAP & SCIAP Sensors
    GM1613998Courtesy of GENERAL MOTORS CORP.
  3. Connect the SCIAP sensor (1) electrical connector.
  4. Install the engine sight shield. Refer to Intake Manifold Sight Shield Replacement .
scientia non olet · About LEMON Manuals