LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System - 4.4L - Introduction (2 Of 2)) >> Repair Instructions >> Supercharger Bypass Regulator Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Supercharger Bypass Regulator Solenoid Valve
    GM1614014Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the bracket and bolt (1) if previously removed.

    Tighten:  Tighten the supercharger bypass regulator solenoid valve bracket bolt to 9 N.m (80 lb in).

  2. Install the bypass regulator solenoid valve (2) to the bracket.
  3. Connect the vacuum line fittings (4, 5) to the bypass regulator solenoid valve.
  4. Connect the electrical connector (3) to the bypass regulator solenoid valve.
  5. Install the engine sight shield. Refer to Intake Manifold Sight Shield Replacement .
scientia non olet · About LEMON Manuals