LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System - 4.4L - Introduction (2 Of 2)) >> Repair Instructions >> Heated Oxygen Sensor Replacement - Bank 1 Sensor 2 >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
NOTE: Refer to Oxygen Sensor Notice.
IMPORTANT:
  • Bank 1 on the LC3 engine is the right side of the engine while sitting in the driver seat.
  • Sensor 2 is the second sensor down stream from the engine towards the rear of the vehicle.
  • A special anti-seize compound is used on the oxygen sensor threads. New service sensors should already have the compound applied to the threads. Coat the threads of a reused sensor with anti-seize compound P/N 5613695 or equivalent.
    Fig 1: Oxygen Sensor Electrical Connector
    GM1652889Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine sight shield. Refer to Intake Manifold Sight Shield Replacement .
  2. Remove the front air inlet housing panel. Refer to Air Inlet Housing Front Panel Replacement .
  3. Disconnect the oxygen sensor electrical connector (2) from the engine wiring harness connector at the rear of the right head.
  4. Note the wire routing and attachment points for reassembly.
  5. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  6. Remove oxygen sensor from the exhaust pipe.
scientia non olet · About LEMON Manuals