LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System - 4.4L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel System Cleaning >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Assemble the fuel system as follows:

  1. Install the fuel injectors and fuel rail. Refer to Fuel Injector and Fuel Rail Replacement .
  2. Install the fuel module assemblies. Refer to Primary Fuel Tank Module Replacement  and Secondary Fuel Tank Module Replacement .
  3. Install the fuel filter. Refer to Fuel Filter Replacement .
  4. Connect the fuel line to the fuel rail. Refer to Metal Collar Quick Connect Fitting Service .
  5. Install the fuel fill pipe cap.
  6. Check the fuel system for leaks.
  7. Install the engine sight shield. Refer to Intake Manifold Sight Shield Replacement .
scientia non olet · About LEMON Manuals